BLADERUNNER AIO OPTIONS AND EXPANSIONS PAGE I          

OPTIONS PAGE II

Advanced Digital Torch Height Controller Card has more features than our previous units and a lower cost. This card plugs into any  series  UBOB based control  and turns it into a complete plasma or plasma/router control solution. With built in test software and direct interface to the control screen, this card earns it's badge as a 3rd generation control, Single cable interface to the BladeRunner I/O card (UBOB).  Custom Plug-ins and Screens for MACH3 gives you total control of the Plasma Cutting experience.

SEE SCREEN SHOT OF DTHC CONTROL BELOW

DTHC Expansion Module Upgrade.  Can be added to ANY BladeRunner AIO unit in the field!

INCLUDED IN BladeRUnner AIO Dragon Cut

Shipped with THC Sensor-PWM module and cable to interface to most brands of plasma units. Optional RAV-01 card needed for plasma units that do not have internal voltage divider card.  Order separately

$375.00

:

Don't let the low price fool you.  This DTHC has features and accuracy that is only found in units costing thousands of dollars! 

  • + - 1/4 V accuracy
  • High speed Sampling for fast response
  • Processor based
  • Totally isolated including Arc Volts
  • Screen Based Interface for presets and readouts
  • Exclusive TIP SAVER (dynamic anti-dive)
  • Comes with Plasma interface card (THC SENSOR CARD)
  • Custom profiles, screens and drivers (plug-ins) included
  • 28 page instruction manual
  • CUT PROFILES stores settings for fast setup.

 

YES!! it will work with HF start units and even High Voltage, High Frequency (aka ESAB larger units).


DTHC Screen Set.

 

Spindle Saver is a defined (by the user) spindle soft start and burn-in profile that provides warming the spindle and bearings up slowly as required by the manufacturer.  Screen settings allow the profile to be applied anytime the spindle has been inactive for over 10 minutes.

 

ISS-02 Spindle Speed Expansion Module
$84.00

With exclusive Spindle Saver technology to use a stepped speed increase on commercial spindles.

Control your VFD (for 3Phase  AC Spindles or your DC  Motor control if equipted with an input for 0-10VDC) from the MACH screen, or from "S" commands in G-code.  The SPS module is extermely linear and uses an embedded processor.  It gets it's speed commands from the UBOB interface (serial connection to MACH) so it does not use up 2 valuable MACH signal pins like the PWM or S&D designs.  The module installs in 5 minutes into the front panel Expansion port of the BladeRunner UBOB Module.  It comes with a remote interface card to make the connections at the VFD easy.  It is totally isolated from PC logic so you don't have to worry about the VFD or DC control not being at the same ground.  It puts out a voltage that is proportional to the percentage of max RPM you define (so if you have a 20,000 RPM spindle and you command 10,000) it puts out 5.0 volts. The card has a RUN relay and REVERSE relay (most VFD's require one or both signals) 

Auto-test functions and custom screens and plug-ins for MACH make this one easy to install and easy to troubleshoot.  Ships with Remote VFD Breakout and 25ft DB9 cable for the Breakout.

OPTIONS PAGE2